Table of Contents
Advertisement
h. Press
(1)
Enter original (4 digits) of handset then press
when enter this menu.
(2)
Enter new password (4 digits) then press
confirm new password.
i.
Press
52.
7. Press
6
to set Base Settings:
When enter this menu, you must enter Base PIN code first (4 digits).
Re: The PIN code is for Base Settings. Default is "0000".
a. Press
Enter the DTMF duration (90~200ms), press
(1)
confirm the setting. Default is 100ms.
Re: Please check with your dealer before you change it. If the duration
not matches with PSTN or PBX setting, it may operate faultily.
b. Press
(1)
Use
press digit key (1~9) directly.
Press
(2)
Re: The default value (600 ms) works in most areas. Changing this
setting may cause Flash key not working. Change only when you
are certain of the new value would work.
Press
c.
Enter 2-digit handset ID followed by pressing
(1)
When register a new handset, the base will assign the specific
(2)
handset ID which assigned in advance to the new handset.
d. Press
Enter 2-digit handset ID followed by pressing
(1)
The base will erase the handset ID from system.
(2)
e. Press
Enter the new Base PIN followed by
(1)
Re: Default Base PIN is "0000".
Press
f.
Use
(1)
Re: When setting "on", the EP902 will automatically hang up if the far
end caller hung up already. However, this function depends on if
there is "dial tone or busy tone" signal sent out by PBX or PSTN,
after the call hung up.
g. Press
8
to Change Password:
9
to set Headset Ring: See Headset Ring operation on Page
1
to set DTMF Duration.
2
select flash key timing. Default is 600ms.
or
SELECT
(Left) soft key to confirm selection.
3
to set Assign Next HS
4
to set Clear HS
5
to Change PIN:
6
to set Auto Hang Up:
CHANGE
(Left) soft key to select and confirm on or off. The
7
to Set Time to support DTMF Caller ID:
to scroll through option 1~9 (100~900ms). Or
~60~
OK
(Left) soft key
SAVE
(Left) soft key to
OK
(Left) soft key to
OK
(Left) soft key.
OK
(Left) soft key.
OK
(Left) soft key.
Advertisement
Table of Contents
