EnGenius EP902 Quick Installation Manual

Base Station Installation

1. Install base station antenna (In normal circumstance, the base station's antenna had installed well during production, no
need to install in addition).
2. Plug the transformer end of the base station AC/DC adaptor into a standard AC electrical power outlet, plug the other end into
the "DC In" jack on the back of the base station.
3. Plug phone cord into the "LINE1" & "LINE2 Jack.
4. A standard telephone or answering machine can be plugged into the adjacent receptacle on the bottom of the base station
marked TEL.

Handset and Charger Installation

1. Plug the transformer end of the Charger AC/DC adaptor into a standard AC electric power outlet, plug the other end into the
"DC In" jack on the back of the Charger.
2. Install battery pack onto the handset.
3. Place handset onto the charger front slot.
4. Fully charge the battery for three hours before use.
5. The phone system is now ready to perform basic functions such as making and receiving phone calls and intercom calls. No
base station or handset programming is needed for basic operations.

Handset Registration

1. Press MENU-7 to enter the registration mode
2. Press and hold the base's
in the registration mode.
3. Press handset key 1 , this completes the registration process. The base station will assign a handset ID between 11 and 19
automatically. The assigned ID will be displayed on the handset LCD, indicating successful registration.

Handset features

1.
TALK/FLASH/SPEAKERPHONE (
a. Places or answers a telephone or intercom call
b. Sends a Flash signal to phone line to retrieve a dial tone after the call ends, or to perform the call waiting feature provided
by local phone companies during a call.
c. Press and hold the key for over 2 second to enable/disable the speakerphone during incoming, outgoing or intercom call.
2. 2-WAY INTERCOM (
a. Places an intercom call to another handset, a group handset (group paging) or all registered handsets.
b. Intercom calls are digital, full duplex, and are conducted without the assistance from the base station.
3.
BROADCAST (
a. Half duplex broadcasting to handsets for immediate announcement
b. Half duplex broadcasting to base stations
Re：Press the
4.
Left/Right Soft Keys (
a. Make menu selection.
5.
Up( ) /Down(
EP902 Quick Installation Guide
REG button for 3 seconds until the base station emits prompt sound to remind you the base station is
)
)
)
key on the left top corner of handset to activate the broadcast function.
)
) Scrolling Keys
1