3.
Attach the holder to the instrument rail mounting block by tightening 2 Phillips
screws removed previously.
4.
Position the holder on the instrument bar of your dental unit, using the cutout space
on the back of the mounting block as a guide.
5.
When the holder is in position, use an Allen key to tighten 2 set screws located at the
bottom of the mounting block.
Figure 3. Handpiece Holder Instrument Rail Installation
2.2.2. Wall-Mounting Option (with Fasteners)
To install the handpiece by fastening it to a wall or other vertical surface, do the following:
1.
Remove the handpiece from its holder before performing this procedure.
2.
Position the holder on a smooth stable vertical surface.
3.
Using the holes on the back of the holder as guides, fasten the holder securely to the
wall using 2 (#6 x 3/4) dry wall screws (not supplied) or other hardware appropriate
to the mounting surface.
Figure 4. Handpiece Holder Wall Mounting Installation
USBCam2 User Guide
B1051061 Rev. –
5