Operation; Operating The Camera - Schick USBCam2 User Manual

4. Operation

4.1. Operating the Camera

Refer to the following sections for instructions on turning the USBCam2 on and off and
taking still images from streaming live video ("freeze-frame" capture).
4.1.1. Turning the Camera On
Before turning on the camera make sure the cable connections are secured. Turn on the
camera by clicking the Power On/Off button (Figure 1, item 2). Removing the handpiece
from its holder also turns the camera on.
4.1.2. Turning the Camera Off
When the camera's light is on, clicking the camera's Power On/Off button (Figure 1, item
2) shuts power off to the camera. Clicking the Power On/Off button restores power to
camera and turns the LEDs back on.
When not in use, store the camera in its holder to protect the device and for easy access.
Placing the camera in its holder turns off the camera automatically.
NOTE: Camera will turn off automatically after 5 minutes of continuous use.
4.1.3. Pausing and Capturing Still Frame Images
NOTE: The following steps apply to the use of USBCam2 with CDR DICOM software.
To set up your handpiece Freeze Frame button for Freeze/Take mode, do the following:
•
Click the Setup button on the Video Capture window
•
Select the option for Freeze/Take
•
Click OK to save settings
To use your handpiece in this mode, depress the Freeze Frame button once (Figure 1, item
3) to capture the frame. To resume live video after taking an image, select any empty
viewbox and click on it.
14
B1051061 Rev. – USBCam2 User Guide