Table of Contents
Advertisement
2. Hardware Setup
2.1. Connecting the USBCam2 and Cable
IMPORTANT! Do not connect the USBCam2 and cable to your computer until after you
have successfully run the setup program. Procedures for installing these files are supplied
in Section 3, "Software Setup."
The USB 2.0 cable used with the camera has a Series "A" USB plug on one side and a
Series "B" USB plug on the other. The "A-type" plug connects to any available USB port
on the computer. The "B-type" plug connects to the handpiece. For EMC and EMI
compliance, the USB cable should not exceed a maximum length of 5 meters (5.5 yards).
2.2. Installing the USBCam2 Handpiece Holder
The USBCam2 Handpiece Holder turns off the camera when the handpiece is inserted and
turns on the camera when the handpiece is removed. The holder is designed for several
mounting options: (1) Mounted to a standard ½-inch dental instrument bar, or (2) Wall-
mounted with fastening hardware.
PLEASE NOTE: When selecting the mounting option for your USBCam2, choose a
location that offers easy access during patient exams and safe storage afterwards. In most
practices, mounting the USBCam2 to the dental unit will provide the best all-around
solution.
2.2.1. Dental Unit Option
To install the handpiece holder to a standard ½-inch instrument bar, do the following:
1.
Remove the handpiece from its holder before performing this procedure.
2.
Remove the cutout block from the holder by untightening and retaining 2 Phillips
screws.
4
Figure 2. USB Cable Connectors
B1051061 Rev. –
USBCam2 User Guide
Advertisement
Table of Contents
