Setting Large Diameter Rolled Label - SATO DR300 Quick Manual

DR300 Quick Guide
Simple Trouble Shooting
Confirm the following items when operation of this equipment failed when the power supply is
on.
Nothing is displayed on the display
Check Point
1. Is the power cable firmly plugged
into the power cable?
2. Is the power cable firmly plugged
into the equipment?
3. Is the power cable damaged?
4. Is the fuse on the main body fine?
5. Is there current supplied to the
equipment?
6. Is the power source fuse or the
circuit breaker for the building
out?
•
Do not operate power switch or plug in/out power cable with wet hands to avoid
electrocution.
•
Disconnect printer from mains before printing.
Pg 20
Remedy
Plug power cable again into the outlet
firmly.
Plug power cable again into the power
connector on the main body firmly.
Replace power cable.
Check the fuse at the right side of main
body. If it is blown, exchange with
equivalent fuse.
If it blows again after exchange, contact
SATO service engineer.
*Please ensure printer is disconnected from
the mains before exchanging fuse.
Check power source for power supply
outlet. If there is no problem with the
power source, check the electricity supply of
the building.
Check for any power shut down.
Contact the building maintenance office.
DR300 Quick Guide

Setting Large Diameter Rolled Label

Method for setting large diameter rolled paper explained.
•
Remove right half of the cover fastened with snap rivets.
•
Pull out 3 snap rivets on the cover by pushing their centre with finger.
•
Alter set position of the label holder.
•
Alter position of the set screw.
•
Insert guide plate in label supply component and rolled label guide.
•
Set large diameter rolled paper.
Pg 13