Modem Module Cable - HP Pavilion dv6 Maintenance And Service Manual

Modem module cable

NOTE: The modem module cable is available in the Cable Kit, spare part number 512832-001. The
modem module cable includes the RJ-11 jack.
Before removing the modem module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Switch cover and keyboard (see
d. Display assembly (see
e. Top cover (see
f. USB board (see
g. System board (see
Remove the modem module cable:
1. Release the clips (1) built into the base enclosure that secure the RJ-11 jack.
2. Remove the RJ-11 jack (2) from the clip built into the base enclosure.
3. Remove the modem module cable (3) from the clips and routing channel built into the base
enclosure.
Reverse this procedure to install the modem module cable.
98 Chapter 4 Removal and replacement procedures
Battery on page 54).
Hard drive on page 63).
Optical drive on page
Switch cover and keyboard on page
Display assembly on page
Top cover on page 85).
USB board on page 92).
System board on page
57).
75).
95).
70).