HP Pavilion dv6 Maintenance And Service Manual page 85

5. If it is necessary to replace the display enclosure or any of the display assembly internal
components, remove the following screw covers and screws:
a. (1) Four rubber screw covers on the display bezel bottom edge. The display rubber screw
covers are included in the Display Rubber Kit, spare part number 513479-001 (15.6-inch
displays) or 512361-001 (16.0-inch displays).
b. (2) Four Phillips PM2.5×5.0 screws.
6. Turn the display assembly upside down, with the bottom edge toward you.
7. Release the display enclosure by sliding the enclosure (1) toward the top of the display assembly.
8. Lift the display enclosure (2) as far as the display logo cable allows.
9. Disconnect the display logo cable (3) from the display panel cable.
10. If it is necessary to replace the display inverter, remove the four Phillips PM2.5×5.0 screws (1) that
secure the display inverter cover to the display bezel.
Component replacement procedures 77