Steps For Firmware Versions 11.06 Or Earlier; Determining The Boot-Block Version - Cisco Aironet 340 Series Hardware Installation Manual

Chapter 4 Troubleshooting
After the access point reboots and the Express Setup screen appears, reconfigure the access point by
Step 10
using the terminal emulator or an Internet browser.

Steps for Firmware Versions 11.06 or Earlier

Follow the steps in this section if your access point is running firmware version 11.06 or earlier.
The following steps reset all configuration settings to factory defaults, including passwords, WEP keys,
Note
the IP address, and the SSID. If you do not need to reset the entire configuration, use the Configuration
Reset buttons on the System Configuration Setup page in the web-browser interface. Consult the Cisco
Aironet Access Point Software Configuration Guide for more information on the reset buttons in the
web-browser interface.

Determining the Boot-Block Version

The steps you follow to reconfigure the access point depend on the version of the access point's boot
block. Follow these steps to find out which boot block version is on your access point:
Open a Telnet session to the access point.
Step 1
Note
Type :cmd and press Enter to switch from text-browser mode to SNMP mode.
Step 2
Type bootblockVersion and press Enter. Text appears with information about the system. If your access
Step 3
point's boot block version is 1.01, the text might look like this:
OID: iso.org.dod.internet.private.enterprises.aironet.awcVx.awcSystem.
bootblockVersion
Value [RO]: 1.01
Type exit and press Enter to return to text-browser mode.
Step 4
Step 5 If your boot block version is 1.01 or earlier, follow the instructions in the
Boot Block Version 1.01 or Earlier" section on page
follow the instructions in the
page
OL-0738-02
You can also use these instructions while communicating with the access point through the
console port or with an SNMP manager. Skip to
"Reconfiguration Steps for Boot Block Version 1.02 or Later" section on
4-7.
Resetting to the Default Configuration
Step 3 if you use an SNMP manager.
4-6. If your boot block version is 1.02 or later,
Cisco Aironet Access Point Hardware Installation Guide
"Reconfiguration Steps for
4-5