Cisco Aironet 340 Series Hardware Installation Manual page 50

Resetting to the Default Configuration
Write down the list of files for future reference.
Step 9
Perform the next six steps carefully to avoid accidently deleting the installation key files or the firmware
Caution
files. You must carefully note the file selection letters, because they change during the following steps.
If you forget to copy the access point's installation key file to DRAM in
it back to configuration memory in
Copy the access point's AP Installation Key to the access point's DRAM by pressing c to select Copy
Step 10
file, then 1 to select DRAM, then the selection letter for the file AP Installation Key.
If the list of configuration files contains a file called VAR Installation Key, you must copy that file to
Step 11
DRAM along with the AP Installation Key file. If the access point does not have a VAR installation key
file, skip to
If you forget to copy the access point's VAR installation key file to DRAM in
Caution
copy it back to configuration memory in
Copy the VAR Installation Key to DRAM by pressing c to select Copy file, then 1 to select DRAM, then
the selection letter for the file VAR Installation Key.
Reformat the access point's configuration memory bank by pressing Ctrl-Z to reach the reformat menu.
Step 12
When the menu appears, press ! to select FORMAT memory bank, then 2 to select Config, then
upper-case Y to confirm the FORMAT command.
Make sure you select the Configuration memory bank for formatting. If you accidentally format a
Caution
different memory bank your access point will stop functioning.
Copy the installation key back to the configuration memory bank by pressing c to select Copy file, then
Step 13
2 to select Config, then the selection letter for the file AP Installation Key.
If you copied a VAR installation key to DRAM in
Step 14
bank by pressing c to select Copy file, then 2 to select Config, then the selection letter for the file VAR
Installation Key. If the access point does not have a VAR installation key file, skip to
Run the access point firmware by pressing r to select Run, then the selection letter for the firmware file
Step 15
that is displayed. The message "Inflating [firmware file name]" appears while the access point starts the
firmware.
When the Express Setup screen appears, begin reconfiguring the access point using the terminal
Step 16
emulator or an Internet browser.
Cisco Aironet Access Point Hardware Installation Guide
4-8
Step
Step 12.
13, your access point will stop functioning.
Step 14, your access point will stop functioning.
Step 11, copy it back to the configuration memory
Chapter 4 Troubleshooting
Step 10, or if you do not copy
Step 11, or if you do not
Step 15.
OL-0738-02