Obtaining And Installing Ipsu; Finding The Access Point's Ip Address - Cisco Aironet 340 Series Hardware Installation Manual

Chapter 3 Basic Configuration

Obtaining and Installing IPSU

IPSU is available on the Cisco web site. Follow these steps to obtain and install IPSU:
Step 1 Use your Internet browser to access the Cisco Software Center at the following URL:
http://www.cisco.com/public/sw-center/sw-wireless.shtml
Click Option 2: Aironet Wireless Software Display Tables.
Step 2
Locate the access point firmware and utilities section and click Cisco Aironet 350 Series (VXWorks).
Step 3
Click IPSUvxxxxxx.exe. The vxxxxxx identifies the software package version number.
Step 4
On the Encryption Authorization Form, enter the requested information, read the encryption
Step 5
information, and check the boxes that apply.
Click Submit.
Step 6
Read and accept the terms and conditions of the Software License Agreement.
Step 7
Select the file again to download it.
Step 8
Download and save the file to a temporary directory on your hard drive and then exit the Internet browser.
Step 9
Step 10 Double-click IPSUvxxxxxx.exe in the temporary directory to expand the file.
Step 11 Double-click Setup.exe and follow the steps provided by the installation wizard to install IPSU.
The IPSU icon appears on your computer desktop.

Finding the Access Point's IP Address

If your access point receives an IP address from a DHCP server, use IPSU to find its IP address. Run
IPSU from a computer on the same network as the access point. Follow these steps to find the access
point's IP address:
When the utility window opens, make sure Get IP addr is selected in the Function box.
Step 1
Step 2 Type the access point's MAC address in the Device MAC ID field. The access point's MAC address is
printed on the label on the bottom of the unit. It should contain six pairs of hexadecimal digits. Your
access point's MAC address might look like the following example:
004096xxxxxx
Note The MAC address field is not case-sensitive.
Step 3 Click Get IP Address.
When the access point's IP address appears in the IP Address field, write it down.
Step 4
If IPSU reports that the IP address is 10.0.0.1, the default IP address, then the access point did not receive
a DHCP-assigned IP address. Steps for assigning an IP address are included in the "Default IP Address"
section in Chapter 3 of the Cisco Aironet Access Point Software Configuration Guide.
To check the IP address, browse to the access point's browser-based management pages. Open an
Step 5
Internet browser.
OL-0738-02
Cisco Aironet Access Point Hardware Installation Guide
Using the IP Setup Utility
3-3