RuggedCom RuggedSwitch M2200 Installation Manual page 2

This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his expense.
This product contains a laser system and is classified as a "CLASS 1 LASER PRODUCT"
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure. This product contains no user serviceable parts. Attempted service by
unauthorized personnel shall render all warranties null and void.
Changes or modifications not expressly approved by RuggedCom Inc. could void the user's authority to operate
Should this device require service see the "Warranty and Service" section of this guide.
The RX1000 family of products should be installed in a restricted access location where access can only be
gained by service personnel or users who have been instructed about the reasons for the restrictions applied to the
location and about any precautions that shall be taken; and access is through the use of a tool or lock and key, or
other means of security, and is controlled by the authority responsible for the location.
Trademarks:
Ethernet is a trademark of Xerox Corporation
RuggedRouter and RuggedRated, are trademarks of RuggedCom® Inc.
©
2008 RuggedCom Inc. All rights reserved
Federal Communications Commission
Radio Frequency Interference Statement
CAUTION
CAUTION
the equipment.
IMPORTANT
2
Rev105