Operating Instructions - Motorola IMPRES WPLN4111 Operating Instructions Manual

OPERATING INSTRUCTIONS

The adaptive charger charges only the Motorola authorized
batteries listed in Tables 1 through 5. Other batteries may not
charge.
The adaptive charger has automatic features and capabilities
that are different from other battery chargers. Pay close atten-
tion to the charge indicator to ensure that the charger is in the
desired/expected mode of operation.
The charger's pocket accommodates either a radio with a battery
attached or a battery alone. Prior to charging a radio with a battery,
turn the radio off. Batteries charge best if they are at room tempera-
ture when charged.
1. Plug the charger end of the power cord into the ac receptacle
located at the back of the charger.
2. Plug the wall receptacle end of the power cord into the appropriate
ac outlet. A successful power-up sequence is indicated by a
SINGLE FLASH GREEN on the charger indicator.
If a battery requires one of the battery adapters (see Tables 3
and 5), push back the battery guide (inside rear of the pocket)
and slide the battery adapter in place. When applicable,
reverse the procedure to remove the adapter.
3. Insert a battery, or a radio with a battery (radio turned off), into the
charger's pocket by:
a. Aligning the groove on each side of the battery with the corre-
sponding raised rail on each side of the charger pocket.
b. Pressing the battery toward the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring complete
contact between the charger and battery contacts.
Once the battery is properly seated into the pocket, the charger indica-
tor illuminates, indicating the charger has recognized the presence of
the battery. Refer to the charging indicators in Table 7 on page 9.
NOTES
NOTE
8