Operating Instructions - Motorola IMPRES Manual

OPERATING INSTRUCTIONS

The adaptive charger charges only the Motorola authorized
batteries listed in Table 1 on page 5. Other batteries may not
charge.
The adaptive charger has automatic features and capabilities that
are different from other battery chargers. Pay close attention to
the charge indicator to ensure that the charger is in the desired/
expected mode of operation.
The charger's pocket accommodates either a radio with a battery attached or a
battery alone. Prior to charging a radio with a battery, turn the radio off.
Batteries charge best if they are at room temperature when charged.
1. Plug the charger end of the power cord into the ac receptacle located at the
back of the charger.
2. Plug the wall receptacle end of the power cord into the appropriate ac outlet. A
successful power-up sequence is indicated by a SINGLE FLASH GREEN on
the charger indicator.
If a battery requires one of the battery adapters (see Table 1),
push back the battery guide (inside rear of the pocket) and slide
the battery adapter in place. When applicable, reverse the
procedure to remove the adapter.
3. Insert a battery, or a radio with a battery (radio turned off), into the charger's
pocket by:
a. Aligning the groove on each side of the battery with the corresponding raised
rail on each side of the charger pocket.
b. Pressing the battery toward the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring complete contact
between the charger and battery contacts.
Once the battery is properly seated into the pocket, the charger indicator
illuminates, indicating the charger has recognized the presence of the battery. Refer
to the charging indicators in Table 3 on page 9.
NOTE
NOTE
8