Operational Safety Guidelines; Operating Instructions; Charging Procedure - Motorola IMPRES NNTN7079 User Manual

6875980C01.book Page 3 Tuesday, December 29, 2015 6:39 PM

Operational Safety Guidelines

• Turn the radio off when charging the battery.
• This equipment is not suitable for outdoor use. Use only in dry
locations/conditions.
• Connect equipment only to an appropriately fused and wired supply
of the correct voltage (as specified on the product).
• Disconnect from line voltage by removing the main plug from the
outlet.
• The socket outlet to which this equipment is connected should be
close and easily accessible.
• Maximum ambient temperature around the charger must not exceed
40 °C (104 °F).
• Make sure the cord is located where it will not be stepped on, tripped
over, or subjected to water, damage, or stress.
• Output power from power supply unit must not exceed the ratings
stated on the product label located on the bottom of the charger.

Operating Instructions

The IMPRES Adaptive Charger System is a fully automated battery
care system. All a user needs to do is follow these simple steps:
1. Place the radio / IMPRES battery into the charger.
2. Remove the radio / IMPRES battery when it's fully charged (LED
turns steady GREEN).
The charger pocket accommodates either a radio with an IMPRES
battery attached or an IMPRES battery alone. Prior to charging a
radio with an IMPRES battery, turn the radio off. Batteries charge
best at room temperature.

Charging Procedure

1. Plug the charger end of the power supply cord into the power
receptacle located at the back of the charger.
2. Plug the wall receptacle end of the power supply cord into the
appropriate AC outlet. A successful power-up sequence is indicated
by a Single Green Blink on the charger indicator.
3