Care Of The Spa Cover; Retractable Cover Systems - HotSpring Vista Owner's Manual

IMPORTANT: Some surface cleaners contain eye and skin irritants. Keep all cleaners out of the reach of children and use care when applying.
®
EVERWOOD SPA CABINET
®
Hot Spring spas include an Everwood spa cabinet. Everwood consists of a rigid polymer that combines the durability of plastic with the beauty of
redwood. Everwood won't crack, peel, blister or delaminate even after prolonged exposure to the elements.
Cleaning of Everwood consists of simply spraying the cabinet with a mild soap and water solution to remove any stains and residue.
Do not rub the Everwood with an abrasive material or use abrasive cleaners as this may damage its texture.
Watkins Manufacturing Corp. recommends touch-up or restaining of the Everwood every three to four years (this will vary according to the
environment). Contact your local dealer for restaining procedures and recommended stains.

CARE OF THE SPA COVER

WARNING: The cover is a manual safety cover that meets or exceeds all prevailing requirements of ASTM Standards for spa safety covers
when installed and used correctly as of the date of manufacture. Non-secured, or improperly secured covers are a hazard. Open the cover to its
fully open position before use.
VINYL COVER
The vinyl spa cover is an attractive, durable foam insulation product. Monthly cleaning and conditioning are recommended to maintain its beauty.
To clean and condition the vinyl cover:
1. Remove the cover from the spa and gently lean it against a wall or fence.
2. With a garden hose, spray the cover to loosen and rinse away dirt or debris.
3. Using a large sponge and/or a soft bristle brush, and using a very mild soap solution (one teaspoon dishwashing liquid with two gallons of water), or
baking soda (sodium bicarbonate), scrub the vinyl top in a circular motion. Do not let the vinyl dry with a soap film on it before it can be rinsed clean.
4. Scrub the cover's perimeter and side flaps. Rinse clean with water.
5. Rinse off the underside of the cover with water only (use no soap), and wipe it clean with a dry rag.
6. To condition the cover after cleaning, apply a thin film of Hot Spring Cover Shield
SERVICE NOTE: To remove tree sap, use cigarette lighter fluid (not charcoal lighter fluid). Use sparingly, and rinse with a saddle soap solution
immediately afterwards, then wipe dry.
Important reminders:
• DO remove snow buildup to avoid breakage of the foam core from the additional weight of the snow.
• DO lock cover lock straps to secure the cover when the spa is not in use.
• DO NOT drag or lift the spa cover using either the flaps, or the cover lock straps.
• DO NOT walk, stand, or sit on the cover.
• DO NOT place any metal or heat transferring object on the cover or place any type of plastic tarp or drop cloth over the cover as this may
result in a melted foam core, which would not be covered under the warranty.
• DO NOT use any lifting mechanisms, chemicals, or cleaners except those recommended by Watkins Manufacturing Corporation, or its
Authorized Sales and Service Dealer.
RETRACTABLE COVER SYSTEM
Clearance required behind cover when open: • CoverCradle
HOW TO OPEN THE VINYL COVER
NOTE: Never attempt to open or remove the vinyl cover by grasping or pulling on the skirting or cover lock straps. The skirting will tear, and torn
skirting is not covered under the terms of the warranty.
Check for ice build-up around the gas springs and pivot points of the retractable cover system. Ice buildup may damage system components.
WARNING: The vinyl cover and retractable cover system are not recommended for use in wind conditions reaching above 25 mph (40 kmh).
NOTE: If your spa is located in an area susceptible to high winds, additional coverlock straps may be installed to minimize wind damage to the cover.
How to Open the Cover
1. With the cover lock straps unfastened, place one hand under the cover skirting, between the spa and cover, to break the cover's vacuum
seal. Then, fold the front half of the cover over onto the back half.
2. If no rear access is available, stand to the side of the spa directly adjacent to the hinge area of the folded cover.
®
A. For the CoverCradle
water) and place the other along the side of the cover, just above the skirt. Gently push (do not lift) with both hands towards the opposite
rear corner of the cover (diagonally). As the cover opens, the gas springs will allow the cover to come to a gentle stop.
®
& CoverCradle II - 24" • UpRite
retractable cover systems: Using both hands, cup one hand under the lower half of the cover (just above the
®
to the vinyl surface and buff to a high luster.
®
Page 48
Spa Care and Maintenance
®
- 7" • GlideRite - 14" • Lift 'n Glide
™
- 7"