Safety Information; Important Safety Instructions - HotSpring Vista Owner's Manual

Portable spas

Hide thumbs Also See for Vista:

Owner's manual (68 pages)

Table Of Contents

Table of Contents

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

AVOIDING THE RISK TO CHILDREN

DANGER:

• RISK OF CHILD DROWNING. Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents,

ensure that children cannot use a spa unless they are supervised at all times.

WARNING:

• To reduce the risk of injury, do not permit children to use this spa unless they are closely supervised at all times.

• To reduce the risk of injury, lower water temperatures are recommended for young children. Children are especially sensitive to hot water.

DO:

• Make sure you always lock the child resistant locks after using the spa for your children's safety. Every Hot Spring

locking cover that meets the ASTM F1346-91 Standard for Safety Covers.

• Test the water temperature with your hand before allowing children to enter the spa to be sure that it's comfortable. Children are

especially sensitive to hot water.

• Remind children that wet surfaces can be very slippery. Make sure that children are careful when entering, or exiting the spa.

DON'T:

• Allow children to climb onto the spa cover.

• Allow children to have unsupervised access to the spa.

AVOIDING THE RISK OF ELECTROCUTION

Risk of electrocution

• Connect only to a grounded source.

• Do not bury the power cord. A buried power cord may result in death, or serious personal injury due to electrocution if direct burial-type

cable is not used, or if improper digging occurs.

• A ground terminal (pressure wire connector) is provided on the control box inside the unit to permit connection of a minimum No. 10 AWG

(6 mm

) solid copper bonding conductor between this point and any metal equipment, metal water pipe, metal enclosures of electrical

equipment, or conduit within five feet (1.5 m) of the unit as needed to comply with local requirements.

WARNING:

• To reduce the risk of electrical shock, replace a damaged cord immediately. Failure to do so may result in death or serious personal injury

due to electrocution.

• Your spa is provided with a Ground Fault Circuit Interrupter for user and equipment protection. To ensure proper operation of this

important safety device, test according to the following instructions per electrical configuration.

Cord-Connected 115 volt, 20 amp models: The GFCI is located at the end of the power cord. Before each use, with the unit operating,

push the TEST button. The unit should stop operating and the GFCI power indicator will go out. Wait 30 seconds and then reset the GFCI

by pushing the RESET button. The GFCI power indicator will turn on, restoring power to the spa. If the interrupter does not perform in this

manner, there may be an electrical malfunction and with it, the possibility of an electric shock. Disconnect the power until the problem has

been corrected.

230 volt, permanently installed or converted models:

• A ground terminal is provided on the terminal block (TB-1, system ground terminal) located inside the control box. To reduce the risk of

electric shock, connect this terminal to the grounding terminal of your electrical service or supply panel with a continuous green, insulated

copper wire. The wire must be equivalent in size to the circuit conductors supplying the equipment. In addition, a bonding terminal

(pressure wire connector) is provided on the outside of the control box for bonding to local ground points. To reduce the risk of electric

shock, this connector should be bonded with a No. 10 AWG (6 mm

within 5 feet (1.5 m) of the spa to comply with local requirements. The means of disconnection must be readily accessible, but must be

installed at least 5 feet (1.5 m) from the spa.

• Your spa is provided with a suitably rated circuit breaker to open all ungrounded supply conductors.