Network Menu - Christie LX400 Manual

NETWORK Menu

Remember that incorrect network settings on this projector
may cause trouble on the network. Be sure to consult with
your network administrator before connecting to an existing
access point on your network.
Select "NETWORK" from the main menu to access the
following functions.
Select an item using the ▲/▼ cursor buttons on the projector or remote control,
and press the ► cursor button on the projector or remote control, or ENTER
button on the remote control to execute the item. Then perform it according to the
following table.
See the User's Manual - Network Guide for details of NETWORK operation.
NOTE • The factory default setting for DHCP is OFF. If your network has
DHCP enabled, and needs to set IP ADDRESS, SUBNET MASK and DEFAULT
GATEWAY automatically, please set DHCP to ON. (
the User's Manual - Network Guide)
• If you are not utilizing SNTP (
- Network Guide), then you must set the DATE AND TIME (
initial installation.
Item
SETUP
(continued on next page)
LX400 User Manual - Operating Guide
Selecting this item displays the SETUP menu
for the network.
Use the ▲/▼ buttons to select an item, and
the ► or ENTER button on the remote control
to perform the item.
Use the ▲/▼ buttons to turn DHCP on/off.
ON
Select OFF when the network does
DHCP
(Dynamic
not have DHCP enabled.
Host
• When the "DHCP" setting changes to "ON", it takes a
Configuration
little time to obtain IP address from DHCP server.
Protocol)
• Auto IP function will be assigned an IP address if the
projector could not obtain an IP address from server
even if DHCP is "ON".
Date/Time Settings of the User's Manual
Description
OFF
55
020-000169-03 Rev. 1 (11-2010)
NETWORK Menu
Network Settings of
57) during the