Air Filter - Christie LX400 Manual

Maintenance
Air filter
Please check and clean the air filter periodically. When the indicators or a
message prompts you to clean the air filter, comply with it as soon as possible.
The air filter has two kinds of filters inside. Replace the filters when they are
damaged or too soiled. To prepare the new filters, make contact with your dealer
and tell the following type number.
Type number = 003-002119-01
When you replace the lamp, please replace the air filter. An air
filter of specified type will come together with a replacement
lamp for this projector.
Turn the projector off, and unplug the power cord. Allow
1.
the projector to sufficiently cool down.
Use a vacuum cleaner on and around the filter cover.
2.
Pull the filter cover knobs while lifting it, to take the filter
3.
unit off.
Use a vacuum cleaner for the filter vent of the projector
4.
and both sides of the filter unit.
If the filters are damaged or too soiled, replace them according
to the following procedure number 5 to 7. Otherwise, please
jump to the procedure number 8.
Pull the filter frame's knob up while holding the filter cover
5.
to remove the filter frame, then take the filters out.
Set new filters where former filters were. Put the larger
6.
meshed filter into a filter cover first. Then put the finer
meshed filter on the larger meshed one.
Put the filter frame back where it was.
7.
Put the filter unit back into the projector.
8.
(Continued on next page)
LX400 User Manual - Operating Guide
(MU05661)
62
Filter cover
Filter cover knobs
Filter frame
Filter (finer meshed)
Filter (larger meshed)
Filter cover
020-000169-03 Rev. 1 (11-2010)
Filter unit