Image Menu - Christie LX400 Manual

IMAGE Menu

From the IMAGE menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button
on the projector or remote control, or ENTER button on
the remote control to execute the item. Then perform it
according to the following table.
Item
ASPECT
OVER SCAN
V POSITION
H POSITION
(continued on next page)
LX400 User Manual - Operating Guide
Using the ▲/▼ buttons switches the mode for aspect ratio.
For an RGB signal
NORMAL 4:3
For an HDMI signal
NORMAL 4:3
For a Video signal, S-video signal or Component video signal
4:3 16:9 14:9
For no signal
4:3 (fixed)
• The NORMAL mode keeps the original aspect ratio of the signal.
Using the ▲/▼ buttons adjusts the over-scan ratio.
Large (It reduces picture)
• This item can be selected only for a video, s-video, component and HDMI signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
Using the ▲/▼ buttons adjusts the vertical position.
Up Down
• Over-adjusting the vertical position may cause noise to appear on the screen. If this
occurs please reset the vertical position to the default setting. Pressing the RESET button
when the V POSITION is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or component video
signal of 480i@60 or 576i@50 input from the COMPONENT port, the range of this
adjustment depends on the OVER SCAN (
when the OVER SCAN is set to 10.
Using the ▲/▼ buttons adjusts the horizontal position.
Left Right
• Over-adjusting the horizontal position may cause noise to appear on the screen. If this
occurs please reset the horizontal position to the default setting. Pressing the RESET
button when the H POSITION is selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or component video
signal of 480i@60 or 576i@50 input from the COMPONENT port, the range of this
adjustment depends on the OVER SCAN (
when the OVER SCAN is set to 10.
Description
16:9 SMALL
16:9 14:9 SMALL
SMALL
Small (It magnifies picture)
above) setting. It is not possible to adjust
above) setting. It is not possible to adjust
29
020-000169-03 Rev. 1 (11-2010)
IMAGE Menu