Table of Contents
Advertisement
OWNER'S MANUAL
FlexFx
The FlexFx Bus in the Sixty-One works differently than a typical effects insert loop. This architecture is
very flexible and opens up many new possibilities not possible with simple effect insert designs found on
other mixers.
The FlexFx Bus is more like an auxiliary bus that can have multiple signals assigned to it. Signals
assigned to the bus may then have external analog effects and external USB effects applied in any
combination. The order of processing in the FlexFx Bus is shown in the graphic below.
1. FLEXFX buttons for DECK 1, DECK 2, MIC and
the Main Mix
(dim
assignment without interrupting audio.
2. ANALOG INSERT is turned on/off with a separate button. The external analog insert can be used with the
INSERT or independently. NOTE: If no external connection is made to the FLEXFX LOOP RETURN jack,
the signal will be interrupted when the ANALOG INSERT button is turned on.
3. The
INSERT is turned on/off with a separate button, used with the ANALOG INSERT or independently.
The
INSERT uses USB record pair 9-10 for the Send, and USB playback pair 7-8 for the Return.
Using the
INSERT generally requires a low latency setting. Adjust latency in the "Rane Drivers" on
page 17.
NOTE: Assign a Deck channel or signal to FLEXFX before engaging the
avoid audible artifacts.
4. The FlexFX CUE is after the analog external insert, USB insert and before the WET / DRY control. This
allows cueing a Wet signal while listening to the Dry signal before fading up to Wet.
1
DECK 1
FLEXFX
DECK 2
FLEXFX
MIC
FLEXFX
AUX
FLEXFX
SIXTY-ONE
16
blue). This allows assigning multiple inputs to the FlexFx Bus and/or changing the
2
SEND
RIGHT
LEFT
SEND
RETURN
ANALOG INSERT
RETURN
RIGHT
LEFT
AUX assign signals to the FlexFx Bus
3
USB
Record
SEND
RETURN
INSERT
USB
Playback
(BRIGHT
BLUE) or
INSERT button to
4
DRY
Main
Mix
WET
Cue
CUE
Bus
FLEXFX
Advertisement
Table of Contents
