Install Engine Guard Covers; Fuel Tank Knee Grip Pads - Honda ST1300 2006 Setup Instructions

2006 ST1300/A
14. Install the engine guard covers.
PARTS
Right engine guard cover
Left engine guard cover
Pan screw 6 x 11 mm
Install the engine guard covers and secure
them with a 6 x 11 mm pan screw.
Torque the screws.
Torque: 9.0 N·m (0.9 kgf·m, 6.6 lbf·ft)
15. Install the fuel tank knee grip pads.
PARTS
Right knee grip pad
Left knee grip pad
Install the optional knee pads if the customer
requests them to be installed.
If the unit has not been sold, store the pads in
the right saddlebag.
Clean the mating surfaces of the fuel tank
with a clean shop towel and isopropyl alcohol
or equivalent.
Peel off the backing sheets and attach the
pads to the sides of the fuel tank 30 mm
(1-13/16 in) from the lower front edges of the
tank, as shown in the illustration.
If the ambient temperature is 77
warm the mating surfaces of the tank and
the pad's adhesive side with a hair dryer
before attaching.
After attaching the pads, press down firmly
over the entire area of the pad to ensure
maximum adhesion.
Avoid washing the motorcycle or riding in
wet conditions for 24 hours after attaching
the pads.
14
QTY
1
1
2
QTY
1
1
°
F or below,
6 x 11 mm
PAN SCREW
FUEL TANK
30 mm
(1-13/16
KNEE GRIP PADS
©2006 American Honda Motor Co., Inc. - All Rights Reserved
30 mm
(1-13/16 in)