Card Retainer Screw - HP 748 Owner's Manual

Figure 4-2
NOTE: Note that, due to clearance problems with the cable connectors, EISA HP-IB
cards cannot be installed vertically adjacent to each other. These should be
installed on opposite sides. If you find it necessary to install an EISA HP-IB card
directly over another one, you will have to use low-profile connectors furnished
by other manufacturers.
4-6
EISA Card Installation
Hardware Installation
Card Retainer Captive Screw

Card Retainer Screw

6 Remove the slot cover plate by pulling it out of the EISA module.
7 Refer to your EISA card installation manual, and then set any configura-
tions that may be required for your application.
8 Install the EISA card in the slot. Make sure its connector is well seated in
the EISA backplane.
9 Replace the EISA card retainer, and then tighten its screw.
10 Slide the EISA module back into the VMEbus chassis, as shown in Figure
4-3, and then tighten its handle screws.