Operating In The Video Solo Mode; Video Mix Effects Chart - Pioneer SVM-1000 Operating Instructions Manual

USING THE VIDEO CONTROL FUNCTIONS

OPERATING IN THE VIDEO SOLO MODE

Setting video solo mode to ON allows instantaneous switching to
the desired channel's video.
By combining with the FADER AV SYNC button ON/OFF, a variety
of operations is possible.
Whenever the power is first turned ON, the video solo mode is set
to OFF by default.
When the video solo mode is ON, the VIDEO SOLO MODE button
will flash.

VIDEO MIX EFFECTS CHART

Video mix effects
Video cross fader
No Name
1 FADE
2 WIPE
3 SWITCH
4 CHROMA-B
5 CHROMA-G
6 LUMINANCE
16
En
Description of the effect
Switches video while mixing.
Switches video while wiping away.
Switches instantaneously (without mixing).
Switches from the blue component of video on cross fader side [A] to the
video on side [B].
Switches from the green component of video on cross fader side [A] to the
video on side [B].
Switches from the dark portion of video on cross fader side [A] to the video
on side [B].
When FADER AV SYNC is ON
• When the channel monitor is touched, output instantaneously
switches to the video of the touched channel.
• When the channel fader begins rising from the [0] position,
output instantaneously switches to that channel's video.
When AV SYNC is OFF
FADER
• When the channel monitor is touched, output instantaneously
switches to the video of the touched channel.
Upon changing the FADER AV SYNC from ON to OFF, the original
channel fader position will be maintained until the channel
monitor is touched again.
Operation of the video cross fader and [TRANS] button are not
supported in the video solo mode.