Table of Contents
Advertisement
SmartNode 4900 User Manual
3. Repeat steps
1
and
4. Verify that the AC power cord included with your IpChannel Bank is compatible with local standards. If it
is not, refer to chapter 6,
compatible power cord.
5. Connect the male end of the power cord to an appropriate power outlet.
6. Verify that the green POWER LED is lit.
Hardware installation is complete. Refer to chapter 4,
page 36.
Installing the power cables—DC units
WARNING
CAUTION
Do not connect the power cables to the DC power source at this time. For the DC power source, the
IpChannel Bank is equipped with a two-position, screw-down terminal block (see
1. Connect the earth ground of the DC source to the grounding stud on the DACS as described in the previ-
ous section entitled "Grounding the Model SN4900—AC and DC units."
2. Strip back the insulation on each of the wires approximately 1/4-inch.
Installing the IpChannel Bank
2
to install the remaining power cable.
"Contacting Patton for assistance"
Mains Voltage: Do not open the case when either power cord is attached. The
SmartNode router is equipped with dual power supplies. Disconnect both
power supply cords before servicing. For systems without a power switch,
line voltages are present within the power supply when the power cords are
connected. The mains outlet that is utilized to power the SmartNode router
shall be within 10 feet (3 meters) of the device, shall be easily accessible, and
protected by a circuit breaker.
The Model SN4900 can only be configured with two AC power
supplies or two DC supplies, you cannot mix AC and DC sup-
plies in the same chassis.
Figure 13. DC connector, -DC and +DC input view
on page 48 to find out how to replace it with
"Getting started with the SmartNode 4900 Series"
- DC input
+ DC input
Grounding stud
3 • Hardware installation
figure
13).
on
34
Advertisement
Table of Contents
