Package Contents - Lindy IPower Control 2x6 User Manual

IPower 2x6
Introduction
Thank you for purchasing the LINDY IPower Control 2x6 Switch. This Switch allows you to control the
supply of power for up to 12 devices via a TCP/IP network. The Switch access is password protected
through a web interface connected by serial or SNMP and is powered by two separate 16A phases, each
powering 6 IEC C14 sockets.
Features
Switching capacity: max 2300W (10A) per channel
•
Total switching capacity up to 7360W (32A)
•
Output: 12 x IEC 320 C14 Sockets
•
Inputs: 2 x IEC 320 C20 Plugs
•
Configurable via web browser or included software
•
Built-in DHCP client
•
Network Connectivity: Ethernet 10/100 Base-Tx
•
Firmware updateable via Ethernet
•
Supports SNMP
•
Dimensions (W x D x H): 483 x 150 x 43mm
•

Package Contents

LINDY IPower Control 2x6
•
12 x Extension cables IEC 320 C13 – IEC 320 C14
•
2 x UK power cords – IEC 320 C19
•
1 x CD containing software & manual
•
This manual
•
Installation & Operation
Ensure all equipment is turned off before connecting the any cables. Once all cables are connected, apply
power to the switch then to each device individually.
1.) Connect the power supply cable to the power socket (h) at the rear of IPower 2x6 and a mains socket.
IPower 2x6 now is booting will soon be ready for use
2.) Plug the Ethernet cable into the connector (c) on the front of IPower 2x6 and connect it to your
Ethernet LAN
3.) Connect the client devices to the active outlets at the rear of IPower 2x6 (i)
a) Power Port LEDs
b) Power supply LEDs
c) Ethernet connector (RJ45)
d) Status LED
e) Buttons "Select" and "OK"
User Guide