Programming Tv/Vcr Combo Control; Setup Codes For Tv/Vcrs - Universal Electronics MILLENNIUM 4 User Manual

Setup Codes for VCRs
(continued):
Shintom 0072
Shogun 0240
Singer 0072
Sony 0035, 0032, 0000, 0033, 0034
Sylvania 0035, 0081, 0000, 0043
Symphonic 0000
TMK 0240, 0208
Tatung 0041
Teac 0000, 0041
Technics 0035, 0162
Teknika 0035, 0037, 0000
Thomas 0000
Toshiba 0045, 0043, 0066, 0212
Totevision 0037, 0240
Unitech 0240
Vector 0045
Vector Research 0038
Video Concepts 0045, 0061
Videosonic 0240
Wards 0060, 0035, 0048, 0047, 0081, 0240, 0000,
0042, 0072, 0149, 0062, 0212
White Westinghouse 0278
XR-1000 0035, 0000, 0072
Yamaha 0038
Zenith 0039, 0000, 0033, 0034
15
PROGRAMMING TV/VCR COMBO
CONTROL
Locate the brand name of your TV/VCR Combo
in the Setup Codes For TV/VCR Combos section
below, and write it in the following space.
TV/VCR Combo Brand:
________________________
The brands are listed in alphabetical order with
popular codes listed first. You will use one of
these codes to program the Millennium 4 to
operate your TV/VCR Combo:
1. Turn on your TV/VCR Combo and insert a
videocassette.
2. On the Millennium 4, press VCR once.
Press and hold SETUP until the LED blinks
twice, then release SETUP.
3. Enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure correctly, the
LED will blink twice.
NOTE: If the LED did not blink twice after entering the code's
last digit, then repeat steps 2 through 3 and try entering the
same code again.
4. Aim the Millennium 4 at your TV/VCR
Combo and press POWER once. The unit
should turn off. If it does not respond, repeat
steps 2-3, trying each code listed for your
brand until you find one that works. If it still
does not work, try searching for the code
(see Searching For Your Code on page 26).
5. If you've located a TV/VCR setup code that works
your TV/VCR Combo and a separate TV code is
also listed, you'll need to program this code into the
Millennium 4 to access volume control (see
Programming TV Control on page 8). If there is no
separate TV code listed, you will need to perform
the following steps to access volume control:
a. Press and hold SETUP until the LED
blinks twice, then release SETUP.
b. Enter 9 - 9 - 3.The LED will blink twice.
c. Press VCR once. The LED will blink
twice.
16