Table of Contents
Advertisement
Device Type:___________________
DVD Code
Device Type:___________________
AUD Code
Device Type:___________________
MTS Code
Device Type:___________________
TV Code
Device Type:___________________
PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo, perform the following
instructions to control this device:
1.
Turn on your TV/VCR Combo and insert a
video cassette.
2.
On the remote control, press AUX once; it
blinks once. Then press and hold SETUP until
the AUX key blinks twice.
3.
Use the "Manufacturer's Codes (Codes Des
Fabricants)" starting on page 54 to locate the
brand name and enter the first four-digit code
for your TV/VCR Combo. If you perform this
procedure correctly, the AUX key blinks twice.
NOTE:
If the AUX key did not blink twice after enter-
ing the codes last digit, repeat steps 2 through
3 and try entering the same code again.
If you've located a TV/VCR setup code that
works for your TV/VCR Combo and a separate
TV code is also listed, you'll need to program
this code into the remote control to access vol-
ume control (see "Programming Device Con-
trol" starting on page 9).
10
Advertisement
Table of Contents
