Programming Device Control - Universal Electronics Potenza ST Manual

PROGRAMMING DEVICE CONTROL

The Potenza ST Universal Remote Control is preprogrammed to operate the set-top box provided by your television
service provider, an RCA TV, a Toshiba DVD player, an RCA VCR, and a Pioneer audio receiver. To control devices
other than the default brands, perform the following steps; otherwise skip this section.
NOTES: For control of a Combo device (for example, a TV/VCR combo), skip this section and per-form
the instructions on "Setting Up a Combo Unit" on page 9. Also refer to "Device Table" on page 7 to find
out which devices can be programmed onto each device key. If you have another brand of set-top box you
would like to control, you'll need to unlock the STB ID Lock before changing the set-top box code (see
"Programming ID Lock" on page 12).
1. Turn on a device and, if applicable, insert video media, (e.g., cassette or disc).
NOTE: Please read steps 2 through 5 completely before proceeding. Highlight or write down the codes
and device you wish to program before moving on to step 2.
2. On the remote control, press a device key once (i.e., VCR, DVD, AUD, TV, or STB ); it will blink once.
3. Press and hold
4. Use the "Manufacturer's Codes" starting on page 17) to locate the type of device and brand name and then enter
the first four-digit code for your device. If performed correctly, the selected mode key will blink twice.
NOTE: If the selected mode key emits a long blink, the entry is invalid. Repeat steps 2 through 4 and try
entering the same code again.
5. Aim the remote control at the device and press POWER once. The device should turn off. If it does not, repeat
steps 2 through 4, trying each code for your brand until you find one that works. If it still does not respond, try
searching for the code (see "Searching for Your Code" on page 9).
NOTE: If the device does not have a POWER key (e.g., DVD and VCR) , press the (Play) key.
6. Repeat steps 1 through 5 for each device you want the remote control to operate. For future reference, write down
each working device code in the boxes below.
TV Code
Device Type:
Code
SETUP until the selected mode key blinks twice, then release SETUP .
AUD Code DVD Code AUD Code STB Code
8