Configuring With The First Use Wizard; Step 4 Configuring With The First Use Wizard - LaCie Ethernet Disk RAIDNetwork RAID Storage System User Manual

LaCie Ethernet Disk RAID
User Manual

4.4. Configuring with the First Use Wizard

Once your Ethernet Disk RAID has been initialized
(as described in section
Disk RAID), follow these steps to run the System Setup
wizard and perform the necessary initial configuration:
1. If you have not already installed the Ethernet Disk
RAID Console, install it (as described in section
Installing the Ethernet Disk RAID
start it (as described in section
sole).
In the left pane, click the name of the Ethernet Disk
RAID. (If you're using both Ethernet ports, the
name of the Ethernet Disk RAID appears twice in
the left pane. You can click either one.) Then click
Log On Storage System
The welcome page appears (Fig. 3.3-A).
2. On the welcome page, click Next. The
Software License Agreement
3.3-B).
3. If you agree to the terms, select the
cense agreement
Host Name page appears.
(Firmware version 1.4)
4.3. Initializing the Ethernet
Console) and
4.2. Starting the Con-
Manager.
End User
page appears (Fig.
I accept the li-
check box and then click Next. The
Configuring Your Ethernet Disk RAID
4.1.
Fig. 4.4.A
Fig. 4.4.B
page