Disabling Remote Boot - LaCie Ethernet Disk RAIDNetwork RAID Storage System User Manual

LaCie Ethernet Disk RAID
User Manual
6. When a message appears, advising you that drivers
will be installed, click OK.
7. When the drivers are installed, one or more mes-
sages might appear, advising you that these driv-
ers are not signed. This has no adverse effect on
your system. Click
each message to proceed with the installation.
In addition, the
starts. Select No, Not this Time
and complete the rest of the wizard, accepting all the
default values. If remote boot was successfully en-
abled (as indicated in the Details area), a new backup
is created automatically.
8. Click Close.
If no problems were encountered, you can now re-
motely boot from the Ethernet Disk RAID (as de-
scribed in section
While Booting
If any problems were encountered, take corrective
action. For example, if you did not previously protect
a system disk or partition, do so now (as described in
section 7.2. Protecting Your
procedure for enabling remote boot until all parts of
the process complete successfully.

7.8.2. Disabling Remote Boot

■
Disabling remote boot restarts your computer auto-
matically. It is recommended that you save and close any
open files on your system before you do this.
To disable remote boot:
1. From the Action
Boot. A progress bar appears, indicating the progress
of the process.
2. When the confirmation message appears, click
OK. Your computer restarts automatically.
(Firmware version 1.4)
Continue Anyway or
Found New Hardware Wizard
on the initial screen
7.9.4. Recovering a System Disk
Remotely.)
Disks). Then repeat this
menu, click Disable Remote
TeChNICAl NOTe:
cessfully enabled but for some reason the new
backup was not created (as indicated in the De-
Yes on
tails area), you must perform a manual backup (as
described in section
Your Disk). You can remotely boot only from
backups that were performed after remote boot
was enabled.
Protecting Local Disks
page 0
If remote boot was suc-
7.3. Manually Backing Up