Starting The Console - LaCie Ethernet Disk RAIDNetwork RAID Storage System User Manual

LaCie Ethernet Disk RAID
User Manual

4.2. Starting the Console

Once you have installed the Console (as described
in section 4.1. Installing the
procedure to start it:
1. Click Start
sole.
As soon as you start the Console, it automatically
scans the network for storage devices. This might
take a few minutes. As soon as the scan is complete,
the left panel displays a tree view of all the storage
devices it found.
Each Ethernet Disk RAID has two ports for con-
necting to the network. If your Ethernet Disk RAID
uses both ports, two items appear in the tree in the
left pane, each using the same name. You can identify
the IP address used by each port by clicking each
item in the tree and observing the IP address area in
the right pane.
2. In the left panel, select the name of the Ethernet
Disk RAID that you want to access (for example,
Storage), and then click
Manager. If your Ethernet Disk RAID uses both
available ports to connect to the network, you can
select either item.
If your Ethernet Disk RAID has not yet been
initialized, the
pears. For more information, refer to section 3.2.3.
If your Ethernet Disk RAID been initialized but not
yet configured, the welcome page for the
up Wizard appears. For more information, refer to
section 4.4. Configuring with the First Use
If your Ethernet Disk RAID has been initialized and
configured, the login page for the Manager appears.
For more information, refer to section
In to the Manager.
(Firmware version 1.4)
Console), use the following
Programs Storage System Con-
Log On Storage System
System Initialization page ap-
System Set-
5.2. Logging
Configuring Your Ethernet Disk RAID
Fig. 4.2.
TeChNICAl NOTe:
Ethernet Disk RAID to the network after the
Console has already scanned it, or if you subse-
quently change the IP address of the Ethernet
Disk RAID, you must click
Systems
the tree in the left pane.
If no Ethernet Disk RAID appears in the left
pane, your computer might not be in the same
subnet as the Ethernet Disk RAID. Be sure to in-
stall the Console on a computer in the same sub-
net as the Ethernet Disk RAID and try again.
Wizard.
If you connect an
Discover Storage
to scan the network again and update
page