Initializing The Disks; Initializing The Disks - LaCie Ethernet Disk RAIDNetwork RAID Storage System User Manual

LaCie Ethernet Disk RAID
User Manual

4.3. Initializing the Disks

Once you have installed the Console (as described in
section 5.2. Logging In to the
connected to the Ethernet Disk RAID (as described in
section 4.2. Starting the
ization page appears (Fig. 4.3.).
Fig. 4.3.
To initialize the hard disks:
1. Click Start. The firmware is uploaded to the hard
disks. When this process is complete, the Ethernet
Disk RAID will restart.
2. Close the browser window. After the system has
restarted, you can perform initial configuration (as
described in section
Disk RAID).
(Firmware version 1.4)
Manager), started it, and
Console), the System Initial-
4.4. Configuring the Ethernet
Configuring Your Ethernet Disk RAID
If not all the hard disks have been detected, or if you
want to add, remove, or re-order the disks at this time,
insert or remove the disks one at a time and click Scan
after each action.
TeChNICAl NOTe:
and Ethernet Disk RAID software are installed
on each disk in your Ethernet Disk RAID to en-
sure that the failure or removal of any one disk
will not cause the entire system to fail.
page 
The operating system