Table of Contents
Advertisement
PROGRAMMING
The numbers between parentheses refer to the fold-out.
Programmed play
•
You can program up to 99 tracks to play in any desired se-
quence.
•
Tracks can be programmed more than once, but each time
counts as a track. (step)
Programming for playback
1 1 1 1 1
Press PROG (11, 85) on the remote control to enter Pro-
gram mode.
PROGRAM flashes and
2 2 2 2 2
Select the required track numbers by turning the REC
LEVEL/SELECT (19) key left or right and store by pressing
PUSH ENTER (19).
or:
Key in a track number with the NUMBER (9, 70). For 2-
digit numbers, press the keys in rapid succession and store
by pressing PUSH/ENTER (19) on ENTER (78).
The track will be stored in the program.
The track number, total program time and the number of
programmed tracks (steps) are displayed.
3 3 3 3 3
Repeat step 2 2 2 2 2 for all tracks to be programmed.
4 4 4 4 4
Press 9 9 9 9 9 (13, 81) or PROG (11, 85) to end programming.
PROGRAM lights continuously.
5 5 5 5 5
Press 2 2 2 2 2 /; ; ; ; ; (14) or 2 2 2 2 2 (73) to start programmed play.
1 1 1 1 1
2 2 2 2 2
•
1 1 1 1 1
appears on the display.
2 2 2 2 2
3 3 3 3 3
16
Clearing a program
Press 9 9 9 9 9 (13, 81) if necessary to stop programmed play.
Press 9 9 9 9 9 (13, 81) again to clear the program.
PROGRAM disappears from the display.
The program is also cleared if you open the disc tray.
Erasing a track from a program
In Stop mode press PROG (11, 85) to enter Program
mode.
Use Q
Q (17, 75) or R
R (18, 80) to select the track from
Q
Q
R
R
Q
R
which to delete.
The track number and program step will be shown on
the display.
Press DELETE/CANCEL (23, 79) to erase the track from
the program.
The remaining program steps and the remaining playing
time of the program will be displayed.
Advertisement
Table of Contents
