Table of Contents
Advertisement
PROGRAMMING
The numbers between parentheses refer to the fold-out.
Programmed play
•
You can program up to 99 tracks to play in any desired se-
quence.
•
Tracks can be programmed more than once.
•
A program for playback can be made from both the disc in
the recorder and the disc in the player. A program for record-
ing can only be made from the disc in the player (CD deck).
Programming for playback
q q q q q
Press PROGRAM (20,62) to enter Program mode.
➔ PROG flashes and
DIG
L
CD - R W
R
w w w w w
Select the required track numbers by turning the MULTI
JOG (21) key left or right and store by pressing PUSH EN-
TER (21).
TRK
DIG
L
CD - R W
R
or:
Key in a track number with the NUMBER (41). For 2-digit
numbers, press the keys in rapid succession.
➔ The track will be stored in the program.
➔ The track number and total program time are displayed.
e e e e e
Repeat step q q q q q to w w w w w for all tracks to be programmed.
r r r r r
Press 9 9 9 9 9 STOP (5, 48) or PROGRAM (20, 62) on the re-
mote control to end programming.
➔ PROG lights continuously.
t t t t t
Press 2 2 2 2 2 /; ; ; ; ; PLAY/PAUSE (6, 56) to start programmed
play.
appears on the display.
PROG
CD
TOTL
TIME
STEP
PROG
CD
Programming for recording
q q q q q
Press REC TYPE (3, 54) to select the required record-
ing mode (see 'RECORDING').
w w w w w
Compile your program as described in "programming
for playback".
•
Only tracks from the disc in the CD player can be stored.
e e e e e
Press 0 0 0 0 0 REC (4, 50) to start recording.
Note:
- To review the program, press PROGRAM (20, 62), followed
by Q (13, 46) or R (14, 57) with the CD player or CD-
Recorder in stop mode.
- To add more tracks to the program, repeat steps q to e.
- If you try to store more than 99 tracks,
pears on the display.
Clearing a program
q q q q q
Press 9 9 9 9 9 STOP (5, 15, 48) if necessary to stop pro-
grammed play.
w w w w w
Press 9 9 9 9 9 STOP (5, 15, 48) again to clear the program.
➔ PROG disappears from the display.
•
The program is also cleared if you open the disc tray.
Erasing a track from a program
q q q q q
In Stop mode press PROGRAM (20, 62) on the remote
control to enter Program mode.
w w w w w
Use Q
Q (13, 46) or R
Q
Q
Q
which to delete.
➔ The track number and program step will be shown on
the display.
e e e e e
Press CANCEL/DELETE (19, 58) to erase the track from
the program.
➔ The remaining program steps and the playing time of the
program will be displayed.
18
R (14, 57) to select the track from
R
R
R
ap-
Advertisement
Table of Contents
