RAM TRUCK 1500 2014 Owner's Manual page 168

166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Activate
1. Select "Automatic High Beams — ON" through the
EVIC. Refer to "Electronic Vehicle Information Center
(EVIC)/Customer-Programmable Features" in "Un-
derstanding Your Instrument Panel" for further infor-
mation.
2. Rotate the headlight switch counterclockwise to the
AUTO (A) position.
3. Push the multifunction lever away from you to switch
the headlights to the high beam position. Refer to
"Multifunction Lever" in this section for further infor-
mation.
NOTE: This system will not activate until the vehicle is
at, or above, 25 mph (40 km/h).
To Deactivate
Perform either of the following steps to deactivate the
Automatic High Beam system.
1. Select "Automatic High Beams — OFF" through the
EVIC. Refer to "Electronic Vehicle Information Center
(EVIC)/Customer-Programmable Features" in "Un-
derstanding Your Instrument Panel" for further infor-
mation.
2. Pull the multifunction lever toward you to switch the
headlights from the high beam to the low beam
position.
3. Rotate the headlight switch clockwise from the AUTO
to the on position.