Out-Of-Range Alarm; Duration; Alarm Sound Type - Hand Held Products 2020 User Manual

Out-of-Range Alarm

Duration

If your image scanner is out range of the base, an alarm sounds from both your
base and image scanner. To activate the alarm options for the image scanner
or the base and to set the alarm duration, scan the appropriate barcode below
and then set the time-out duration (from 0-3000 seconds) by scanning digits on
the Programming Chart
sec (no alarm).
Base Alarm Duration
Note: If you are out of range when you scan a barcode, you will receive an error
beep even if you do not have the alarm set. You receive the error beep
since the data could not be communicated to the base or the host.

Alarm Sound Type

If you have set the out-of-range alarm enabled, you may change the alarm type
for the image scanner or base by scanning the appropriate barcode below and
then scanning a digit (0-7) barcode and the Save barcode on the
Chart inside the back cover of this manual. Default = 0. Set the sound type to fit
your application.
Base Alarm Type
1 - 14
inside the back cover, then scanning Save. Default = 0
Image Scanner Alarm
Image Scanner Alarm Type
2020/3820 User's Guide
Programming