Magnum 261805 Operation Manual page 9

3. Place prime tube in
waste pail.
4. Submerge Suction tube in
water or flushing solvent.
5. Plug sprayer in to a grounded outlet.
6. Set AllControl to PRIME/CLEAN
PUMP.
7. When sprayer starts pumping, flushing solvent and
air bubbles will be purged from system. Allow fluid to
drain out of prime tube, into waste pail, for 30 to 60
seconds.
8. Turn AllControl OFF.
9. Transfer Suction tube to paint pail and submerge
Suction tube in paint.
10. Turn AllControl to PRIME/CLEAN
PUMP.
11. When you see paint starting to
come out of prime tube:
a. point gun into waste pail.
312082B
ti9652a
ti9651a
ti9169a
ti9168a
ti9169a
b. unlock gun trigger lock.
c. pull and hold gun trigger.
d. set AllControl to
PRIME/CLEAN GUN &
HOSE.
12. Continue to trigger into waste pail until you see only
paint coming out of gun.
13. Release trigger. Engage trigger
lock.
14. Transfer drain tube to paint pail and clip prime tube
to Suction tube.
• Motor stopping indicates pump and hose are
primed with paint.
• If motor continues to run the sprayer is not
properly primed. To reprime repeat step 6.
15. If spraying, install tip and guard on gun, page 10
and see Spraying Techniques, page 10.
If rolling, roller setup and Rolling Techniques, begin
on page 15.
Getting Started
ti8922a
ti9171a
ti8923a
9