Table of Contents
Advertisement
Step 12 is for returning paint in hose back to paint
pail. One 50-ft hose holds approximately 1-quart
(1-liter) of paint.
12. To preserve paint in hose:
a. Point gun into paint pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Turn AllControl to
PRIME/CLEAN GUN &
HOSE.
e. Continue to hold gun trigger until you see paint
diluted with flushing fluid starting to come out of
gun.
13. While continuing to trigger
gun, quickly move gun to
redirect spray into waste
pail. Continue triggering
gun into waste pail until
flushing fluid dispensed
from gun is relatively clear.
312082B
14. Stop triggering gun. Engage trigger lock.
15. Turn AllControl to OFF.
16. Fill unit with Pump Armor
17. Clean gun fluid filter
ti8922a
ti9171a
18. Clean tip and guard
19. Wipe paint off outside of gun using a soft cloth
ti9745a
ti8923a
Term Storage, page 21.
(d) with water or
flushing solvent and
a brush every time
you flush the system.
Replace gun filter if
damaged.
with water or flushing sol-
vent. A soft brush can be
used to loosen and remove
dried on material if needed.
moistened with water or flushing solvent.
Shutdown and Cleaning
™
storage fluid. Read Long
d
ti9257a
ti9671a
17
Advertisement
Table of Contents
