Magnum 261805 Operation Manual page 14

Rolling
Setup
• Follow Priming instructions, beginning on page 8,
prior to assembling roller.
• After priming, only paint should come out of spray
gun. Water in hose line will cause paint to run.
1. Set AllControl to lowest
ROLL setting.
2. If installed, remove tip and guard assembly from
gun.
3. Make sure gasket is in place in bottom of roller
frame.
4. Attach pressure roller
assembly to gun.
5. Rest roller on flat surface
and align gun with roller.
14
Tighten nut with wrench while keeping gun and
roller aligned.
6. Unlock gun trigger safety. Trigger
gun. Roll surface until paint is fully
dispersed on roller. This may take a
minute.
• Trigger gun briefly only when you need more
paint.
• The best operating pressure is the lowest
ti9170a pressure that provides an even paint supply to
the roller. This typically does not exceed 300
psi (2.1 MPa, 21 bar).
7. Increase pressure only if triggering gun does not
supply enough paint for your rolling speed.
8. Whenever you stop painting, relieve pressure,
page 7 and elevate roller end of extension tube to
prevent paint from draining out.
9. Flush the pump, gun and pressure roller immedi-
ately after each use to prevent paint from drying in
the pressure roller and damaging it. See Shutdown
and Cleaning, beginning on page 16.
ti9339a
ti9650a
Rolling
ti8922a
312082B