Fujitsu M3097DG Oem Manual page 62

Operation and Maintenance
(3) Angle the document edges as follows to avoid double feed.
a)
b)
c)
(4) Place the documents on ADF paper chute as follows
a)
b)
c)
d)
5-8
Lift the documents holding the both ends with both hands.
Hold the documents tightly with your left hand, and bend the documents as shown in
B.
Grip tightly with your right hand, loosen the grip of your left hand, and straighten the
documents as shown in C.
Open the right and left guides of the ADF paper chute about 5 mm wider than the
document width
Place the documents with front side down onto ADF paper chute with the top edges
facing the ADF.
Adjusts the right and left guides to the document sides. Skewing may occur if there is
a gap between the guides and documents.
Slides the documents down until they touch the pick roller in the ADF. If the
documents hit the pick roller in ADF hard, two or more sheets may be fed at once.
Make sure that the upper end of documents are not turned.