Fujitsu M3097DG Oem Manual page 200

B.9 General Remarks
These are not the interface deference between M3097DG and M3093DG, but may be useful
information for the driver engineers.
B.9.1 Command sequence
At Flatbed or ADF (simplex) or ADF (duplex) reading, the following command sequence is
recommended.
FB reading : Set window (front) --> SCAN (front) --> READ (front) --> SCAN (front) -->
READ (front) -> ...
ADF(simplex): Set window (front) --> Object Position (Load) --> SCAN (front) --> READ
(front) --> Object Position (Load) --> SCAN (front) --> READ (front) --> .......
ADF(duplex) : Set window (duplex) --> Object Position (Load) --> SCAN (duplex) --> READ
(front) --> READ (back) --> Object Position (Load) --> SCAN (duplex) -->
READ (front) --> READ (back) --> .......
Notice: If the Object position (Load object) is issued without the SET command of duplex
reading, the scanner returns the error below;
Status:
Sense key:
Additional sense code:
Additional sense code qualifier:
B.9.2 Additional sense code/ Additional sense code qualifier
Following sense code and sense code qualifier are missing in M3093DG OEM manual but the
scanner can report.
Table B.9.1 Sense code and sense code qualifier not in OEM manual
Sense Additional
Key sense code
5 00
5 1A
B 45
B 47
B'00001'(CHECK CONDITION)
B'5' (ILLEGAL REQUEST)
B'26'
B'00'
Additional
sense code
qualifier
00 Page end is detected before reading (VGATE
ON) when the page end detection is enabled.
00 Parameter length illegal
00 SELECT/RESELECT FAILURE
00 SCSI parity error
B.9 General Remarks
Description
Appendix B-5