Fujitsu M3097DG Oem Manual page 166

Scanner Interface
•
BLOCK DESCRIPTOR LENGTH: Byte 3
Specifies the length of the entire mode parameter descriptor block in units of byte. The page
and vendor-specific parameter are not included.
In this scanner, 0 is specified and the succeeding mode descriptor section shall be omitted.
b. Mode parameter descriptor block (Omitted in this scanner)
The mode parameter data (mode descriptor block) is shown below:
7
Byte 0
1
(MSB)
2
3
4
5
(M S B)
6
7
•
NUMBER OF BLOCKS: Byte 1 to 3
Specifies the number of logical blocks fitted for the DENCITY CODE and BLOCK
LENGTH.
•
BLOCK LENGTH: Bytes 5 to 7
Specifies the length of the logical blocks described in the BLOCK DESCRIPTOR in units of
byte.
Note:
In this scanner, this descriptor is omitted.
Appendix A-96
6 5 4
Number of blocks
Parameter list length
Block length
3 2
(Reserved)
1 0
(LSB)
(LSB)