Fujitsu fi-6110 Operator's Manual page 141

Chapter 9 Operational Settings
3
Adjust the level of offset/vertical magnification as needed.
Offset Setting
Unit Select [ADF (front)] or [ADF (back)] as the
target for offset adjustment.
Main Adjusts the horizontal (width) offset.
The value can range from -2 to +2 mm (in
increments of 0.5).
Sub Adjusts the vertical (length) offset from the top
of the page.
The value can range from -2 to +2 mm (in
increments of 0.5).
End of page Adjusts the vertical (length) offset from the
bottom of the page.
The value can range from -2 to +2 mm (in
increments of 0.5).
Vertical
magnification
Adjustment
Unit The target for vertical magnification
adjustment is fixed to [ADF].
Vertical Adjusts the vertical (length) magnification.
magnification The value can range from -3.1 to +3.1% (in
Adjustment (length) increments of 0.1).
Description
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Description
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
TOP
Contents
Index
Introduction
Appendix
Glossary
141