Turning The Power On/Off; How To Turn The Power On; How To Turn The Power Off; Various Ways To Scan - Fujitsu fi-6110 Operator's Manual

Chapter 1 Scanner Overview

1.3 Turning the Power ON/OFF

This section explains how to power on/off the scanner.
The method by which the scanner is powered ON/OFF can be
specified from one of the following:
Press the [Power] button on the operator panel
Unplug the power cable then plug it back in
Have the scanner turn ON/OFF in sync with the
computer's power
For details, refer to "Method of Turning the Scanner ON/OFF
[Power SW Control]" (page

How to Turn the Power ON

1
Press the [Power] button on the scanner's operator panel.
The power is turned on, and the [Power] button lights in green.
During initialization, the Function Number Display of the operator
panel changes as follows: "8"
ready when "1" is displayed.
When you press the [Power] button, the Check LED will
flash once. Note that this is an initial diagnosis and not a
malfunction.
152).
Check
Function
Send to
Scan
/Stop
Power
[Power] Button
"P" "0" "1". The scanner is

How to Turn the Power OFF

1
Press the [Power] button on the operator panel for more
than two seconds.
The power is turned off, and the [Power] button switches off.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
18