Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Oricom Secure 50
Summary of Contents for Oricom Secure 50
- Page 1 Baby Monitor Secure 50 User Guide...
-
Page 2: Table Of Contents
TABLE OF CONTENTS WARNINGS AND SAFETY INFORMATION GETTING STARTED YOUR BABY MONITOR BASIC OPERATION TROUBLESHOOTING PRODUCT SPECIFICATIONS GUARANTEE... -
Page 3: Warnings And Safety Information
Please read this user guide thoroughly before use. Never use or place your Parent or Baby units in or near Your ORICOM Baby Monitor is designed to be an aid and moisture or water (e.g. near bath or pool). Immersing in should not be used as a substitute for responsible and water can cause electric shock and even death. - Page 4 Always carry out repairs there is gas leaking. through your authorised ORICOM representative or • As there is a slight chance that the product could be other duly qualifi ed tradesperson.
-
Page 5: Getting Started
GETTING STARTED Installation Thank you for choosing this monitor from Oricom. Your Secure 50 Baby Monitor offers the best Digital Technology. For the Parent Unit clip 1 Remove the Belt Clip by lifting the clip at the top and sliding it INTERFERENCE downwards. - Page 6 GETTING STARTED 5 Press [ ] to turn the Parent Unit on. 4 Press [ ] to turn on the Baby Unit. • Before fi rst use, or if it has been out of use for a long • The Baby Unit should be placed about 1 metre time, the Parent Unit will need to be charged for 15-16 to 1.5 metres away from the baby's cot on a flat hours.
-
Page 7: Your Baby Monitor
YOUR BABY MONITOR Baby unit (Sender) 1 Night light Key Press to turn On the night light. Press again to turn off the Light. 2 Power On/Off Key Press to turn the Unit ON. Press and hold to turn the Unit OFF. 3 Page Key Press and hold this key, Parent unit makes an audible alert. - Page 8 YOUR BABY MONITOR Left view of baby unit Parent unit (Receiver) 6 DC 6V input 7 Battery Cover Connecting to Power Adaptor. Rechargeable batteries. 8 Belt Clip 9 Volume Up/Down Keys Adjust the Volume at which you hear the sounds in your baby's room.
-
Page 9: Charger Pod
YOUR BABY MONITOR Charger Pod 11 Power Light Red light when the power is ON. 14 Charging Light Flashing light indicates rechargeable batteries need When Parent unit is placed in the Charger Pod, the recharging. red charger light comes ON to indicate the batteries 12 Battery/Noise Level Indicators are charging. -
Page 10: Basic Operation
BASIC OPERATION Once you have set up your Baby Monitor, you will be able and 3 red). The more audio is picked up, the more to hear the sounds in your baby's room through the Parent lights will be lit. When no audio is picked up, all 8 Unit. -
Page 11: Night Light
BASIC OPERATION Low Battery • To stop the Page alert, press any button on the Parent Unit, or press [ ] again on the Baby Unit. Note: Baby Unit If no button is pressed, the paging tone will stop after 30 When the battery power is low, the power light will fl... - Page 12 BASIC OPERATION Rechargeable batteries in the Parent unit give up to 10 hours continuous usage. Please note however, that new 8 lights illuminated fully charged batteries do not reach full capacity until they have been in normal use for several days. Running rechargeable batteries right down at least once a 6 lights illuminated half charged...
-
Page 13: Troubleshooting
TROUBLESHOOTING Problem Possible cause(s) The red power lights do not turn on when you plug 1. Check if the units are properly connected to the power supply. in the power. 2. Check if the power is turned on. If not, Press [ ] to turn on the power. -
Page 14: Product Specifications
PRODUCT SPECIFICATIONS Feature Specifi cations Operating Frequency DECT 1.8 GHz Up to 300m under optimum conditions. The range is Range reduced in buildings (up to 50m) as a result of walls, doors etc. Input: 240 V 50Hz Power supply (baby unit) Output: 6 V , 200 mA, Non rechargeable batteries (baby unit) -
Page 15: Guarantee
Oricom. by the use of parts not manufactured or sold by Oricom; or Oricom is not liable for any damages caused by the product or the failure by modifi cation or service by anyone other than: of the product to perform, including any lost profits or savings or special, (a) Oricom;... - Page 16 - Email our customer support team on support@oricom.com.au - Contact Oricom Customer Support team on 1300 889 785 or 02 4574 8888 (Monday to Friday 9am to 5pm EST) Please retain your purchase receipt and attach to the back page of this user guide.
Need help?
Do you have a question about the Secure 50 and is the answer not in the manual?
Questions and answers