Port-based VLAN
If you set the VLAN mode to Port-based VLAN, each physical switch
port is configured with an access list specifying membership in a set of
VLANs.
You could find the status in the Port-based VLAN configuration page
show "Enable". The default VLAN ID for each port is "1".
Warning:
QoS function would be "Disable" while Port-
based VLAN function is "Enable"
Figure 3.19: Default Port-based VLAN Setting Screen
To configure the port-based VLAN, you have to choose the VLAN ID
from the pull down menu first. Second, choose the port member for this
VLAN ID via click the icon under the port number. Finally, don't forget
to click Apply to finish your setting for this VLAN ID.
Fig 3.20 shows ports 2 & 3 belong to the same VLAN group — VID= 2.
Warning:
The default VID=1 should be removed or
changed before you configure the port-based
VLAN. If you didn't remove or change it,
default VID=1 would allow packets transmitted
and received between all ports, and your
optional configuration would be ineffective.
37
Chapter 3