Table of Contents
Advertisement
C
ONFIGURING THE
For QinQ operation, a customer port should be set to VLAN unaware
and a provider port (trunk port) should be set to VLAN aware.
• QinQ – A QinQ enabled port will accept packets up to 1526 bytes in
length, which means double tag header frames can be accepted.
QinQ should be enabled for provider ports but not for customer ports.
Note: QinQ "customer" ports are those ports that are connected to
• Packet Type – Sets the interface to accept all frame types, including
tagged or untagged frames, or only tagged frames. When set to receive
all frame types, any received frames that are untagged are assigned to the
default VLAN. PCs should be connected to ports with Packet Type set
to "All." PCs cannot, in general, send or receive tagged packets. Switches
should be connected to each other with Packet Type set to "Tagged." If
the Packet Type is set to "All," the port can accept incoming tagged and
untagged packets. Untagged packets will be associated with the VLAN
identified by the PVID. Tagged packets will be dropped unless the port
is a member of the VLAN identified by the VLAN tag in the packet.
Outgoing packets will be tagged unless the packet's VLAN ID is the
same as the PVID. If the Packet Type is set to "Tagged," the port will
drop untagged packets and will only send and receive tagged packets.
Tagged packets will be dropped unless the port is a member of the
VLAN identified by the VLAN tag in the packet. The PVID has no
effect in this case.(Option: All, Tagged; Default: All)
• PVID – VLAN ID assigned to untagged frames received on the
interface. The PVID (Port VLAN ID) is the VLAN ID that is associated
with untagged, ingress packets. It is not possible to remove a port from
VLAN 1 unless its PVID has been changed to something other than 1.
The PVID has no effect on ports that have Packet Type set to Tagged.
(Default: 1)
5-32
S
WITCH
normal VLAN aware switches in the customer's network. QinQ
"network" ports are those which are connected to the service
provider's network. To tunnel packets through a service
provider's metro network, QinQ needs to be enabled on the
network port.
Advertisement
Table of Contents
