Table of Contents
Advertisement
FS-8700-39 EST3 Driver Manual
Appendix E. Driver Error Messages
Error Message
EST3:#01 FYI. For an
Old EST3 Panel, Read
MD length must be even.
EST3:#02 Err. Read MD
length must > 0 and <=
%d
EST3:#03 Err. Write MD
must have length = 1
EST3: #04 Unknown
Escape Sequence 1B
%02X considered as
%02X
6
Download the configuration file, make the necessary changes, upload to the FieldServer and cycle
power to the FieldServer for the changes to take effect.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Description and Action Required
This message will be displayed once if any Map Descriptor in a configuration
file has an odd length. Old EST3 Panels (before 2002) simply do not
communicate if length is odd.
This message can be ignored if it is new EST3 panel. But if it is old or
unknown, try making Map Descriptor having even length before contacting
technical support.
Numbers of addresses to be read per request are limited.
Edit configuration file to set Map Descriptor length within specified range.
One Map Descriptor can write only 1 value. Change length to 1
This message is printed if the FieldServer receives sequences that are not
specified. Specified sequences are 1B 82, 1B 8D and 1B 9B. This message
is for information only and can be ignored unless the data stored by the
FieldServer is invalid in which case, call Tech support.
Page 21 of 21
6
6
.
Advertisement
Table of Contents
