Setting The Vehicle Gap - Ford Transit Owner's Manual

Using the System
Use the steering wheel controls to operate
the system.
A Set speed increase
B Set speed decrease
C On and off
D Gap increase
E Gap decrease
F Cancel and resume
Switching the System On
Press switch C. The system is set to
standby mode.
Setting a Speed
Press switch A or B to select your set
speed. The speed is stored as a set speed
and displayed in the information display.
Note: The system must be in standby
mode.
Transit (TTG) Vehicles Built From: 06-01-2014, Vehicles Built Up To: 31-12-2014, CG3612en enGBR, Edition date: 12/2013
Cruise Control
Changing the Set Speed
Press switch A to increase or switch B to
decrease the set speed until the desired
set speed is shown in the information
display. Your vehicle speed will gradually
change to the selected speed.
Note: Vehicle speed may be increased and
decreased at intervals of 5 mph or 5 km/h
depending on your unit of measure setting.
Note: If the system does not react to these
changes the reason may be that the gap
interval to the vehicle in front of you
prevents an increase in speed.

Setting the Vehicle Gap

The distance between you and the vehicle
detected in front of you is maintained by
a variable setting. The information display
will show the variable setting as horizontal
bars. Selecting one bar gives the smallest
gap and selecting all bars gives the largest
gap. When in standby mode the bars are
empty and when in use they are full.
When the system does not detect a vehicle
in front of you, you will only see your
vehicle displayed in the information display
below the bars. The system will maintain
the set speed when conditions permit. The
system also maintains the set gap and
displays this in the information display.
121